Position 7 MTR Adjustable Cheek Riser

MTR Cheek Riser Precision Fit. Adjustable Height. Your Setup, Your Way. The CZ 457 MTR is built for accuracy—but without a proper cheek weld, you’re leaving performance on the table. This adjustable cheek riser is designed specifically for the MTR stock, giving you a stable, repeatable head position and perfect eye alignment with your optic. It will also work with other stocks with a max width below 45mm. Fully Adjustable for Any Setup Getting your cheek height just right is critical. This system uses a modular spacer design, allowing you to fine-tune elevation exactly to your needs. Included spacers: 1× single spacer (3 mm) 1× double spacer (6 mm) 2× quad spacers (12 mm each) By combining them, you can achieve an adjustment range from 3 mm up to 33 mm, covering everything from low-profile scopes to high-mounted optics. Two Mounting Options Choose the installation method that fits your build: 1) Screwed Mount (Recommended) For maximum strength and long-term reliability: 1) Position the cheek rest on the stock in your desired location 2) Mark the center of each hole 3) Use a 3.5–4 mm drill bit to create pilot holes 4) Screws provided are 4.5 mm 5) Mark 30 mm depth on your drill (use tape as a depth stop) 6) Drill straight, ensuring holes are perpendicular to the cheek rest 7) Stack spacers to your desired height and secure This method provides the most solid and competition-ready setup. 2) Glued Mount (No Drilling Required) If you prefer a non-invasive installation: Use 3M VHB double-sided tape (not included) to attach the bottom spacer to the stock Use super glue (or similar) to bond the remaining spacers and cheek rest Important: Make sure you are 100% satisfied with the height before gluing—this setup is permanent and not easily reversible. Clean Design, Purpose Built The riser follows the natural lines of the CZ 457 MTR stock, maintaining a low-profile, functional look. No unnecessary bulk, no interference—just a clean upgrade that works. Built for Consistency A consistent cheek weld means: -Better recoil control -Faster follow-up shots -Improved shot-to-shot repeatability In precision shooting, small details matter—and this is one you’ll feel immediately. Compatibility -Designed specifically for CZ 457 MTR stock -Fitment on other stocks is not guaranteed but should work with stocks thinner than 45mm. What’s Included -Cheek riser -Spacer set (3 mm, 6 mm, 2× 12 mm) -Mounting screws (4.5 mm) (3M VHB tape not included)